Gear sets are assemblies of two or more meshing gears working together to adjust torque, rotational speed or direction within power transmission systems.
This photo showcases a typical example of a lapped bevel gear set made by BELON used for gearbox. Gear lapping is a precision finishing process for hardened spiral bevel gear sets. Abrasive slurry (silicon carbide or aluminum‑oxide particles in carrier fluid) is applied between meshing teeth. Gears rotate under controlled pressure, speed and duration; abrasives micro‑remove surface peaks and optimize high‑pressure contact zones, forming a contact interface matching real‑world load distribution, compensating for shaft deflection, housing deformation, thermal expansion and bearing clearance that theoretical calculations cannot fully predict.
Process adopts multi‑stage abrasives: coarse grades for fast stock removal, then finer compounds to achieve surface roughness ≤Ra 0.4 μm (down to Ra 0.2 μm for high‑performance use). Key parameters: lapping pressure 200‑600 N, rotating speed 100‑300 RPM with forward‑reverse alternation, cycle time from 30 seconds to several minutes. Abrasive slurry is recirculated and filtered. Operators inspect tooth‑contact patterns with Prussian‑blue marking compound and fine‑tune parameters to meet specs.
BELON has focused on the gear manufacturing industry for more than 15 years and has the comprehensive abilities to manufacture various types of gear sets meeting your application requirements.


























